I want to bring to your attention a master class on making sprigs of greenery foamirana. This branch would be marvelous complement in the composition and any accessory.
We will need:
Foamiran any light shade (I have a light lemon).
Teip-white tape.
Floral wire (I have white №28.)
Oil paint white, emerald green and light green colors (all shades of green).
Super glue.
A piece of sponge.
Mold.
Iron scissors.
Cut the required number of petals (I do usually 5-7 pieces per twig). Cut is best of the hand that petals have turned out a little different (this adds naturalness). If it is difficult, you can take any the pattern of a leaf, the main thing that he was a "foot".
Heat the leaves are putting on the iron and to Molde.
Mix green paint with white so that we've got three shades. Apply with a sponge on the edges of petals darkest dye. Then a lighter shade to shade the edges. It is better to take a new sponge.
The reverse side of the petal and toning.
Get here are the leaves.
Next we are putting an edge to iron each sheet with two sides.
Stretch the edge in different directions (do a little wavy edges).
Some leaves can still be heated and pinched the tip.
Lightly (not to spoil our impression from Mold) form a groove.
We get here a leaf.
Getting to the assembly branches.
Take the tape and winding the wire a little bit - about two centimeters on.
Glue on the super-glue wrapped piece of wire to the back of the sheet. We are putting a wire so that the "tail" of a leaf can be hidden by wrapping teip-tape.
Wire is wound on.
Bonding base other leaves superglue.
wrapping tape on, picking up the next sheet.
Thus is formed a twig with the desired frequency and splendor leaf arrangement.
Sponge with the same dye to stain the stem to match our leaves.
All :) Our branch is ready! The perfect complement to delicate bouquet or accessories!
source: liveinternet
Foamiran any light shade (I have a light lemon).
Teip-white tape.
Floral wire (I have white №28.)
Oil paint white, emerald green and light green colors (all shades of green).
Super glue.
A piece of sponge.
Mold.
Iron scissors.
Cut the required number of petals (I do usually 5-7 pieces per twig). Cut is best of the hand that petals have turned out a little different (this adds naturalness). If it is difficult, you can take any the pattern of a leaf, the main thing that he was a "foot".
Heat the leaves are putting on the iron and to Molde.
Mix green paint with white so that we've got three shades. Apply with a sponge on the edges of petals darkest dye. Then a lighter shade to shade the edges. It is better to take a new sponge.
The reverse side of the petal and toning.
Get here are the leaves.
Next we are putting an edge to iron each sheet with two sides.
Stretch the edge in different directions (do a little wavy edges).
Some leaves can still be heated and pinched the tip.
Lightly (not to spoil our impression from Mold) form a groove.
We get here a leaf.
Getting to the assembly branches.
Take the tape and winding the wire a little bit - about two centimeters on.
Glue on the super-glue wrapped piece of wire to the back of the sheet. We are putting a wire so that the "tail" of a leaf can be hidden by wrapping teip-tape.
Wire is wound on.
Bonding base other leaves superglue.
wrapping tape on, picking up the next sheet.
Thus is formed a twig with the desired frequency and splendor leaf arrangement.
Sponge with the same dye to stain the stem to match our leaves.
All :) Our branch is ready! The perfect complement to delicate bouquet or accessories!
source: liveinternet
No comments:
Write comments